Secondary 4 Additional Mathematics · Notes
Reverse differentiation, prepare difficult integrands and distinguish signed accumulation from geometric area.
Integration and Area summary and formula sheet: every method on 5 pages
A summary of the whole integration and area chapter on five pages.
Page 1 of 5 Standard and definite integrals Part 1: techniques and definite integrals
A Maths summary notes
Integration and area formulas and methods, section by section
Page 1 of 5Standard and definite integralsPart 1: techniques and definite integrals
Integration reverses differentiation: the standard integrals
| Integral | Result |
|---|---|
- If , then . With no limits (an indefinite integral) write , because every constant differentiates to .
- Write in powers first: , , and . Warning: the stays below, so it is , not .
- The table gives the result for each standard form. The highlighted results are and .
- Check by differentiating your answer back. Sine, cosine and are the only trigonometric forms integrated directly.
A sum of standard terms: create the a
- Question: integrate with respect to . Create the inside, and put outside.
- The working: .
- Warning: divide by too. , not .
- Warning: a negative flips the sign. .
- Warning: only gives . , which integrates to .
Definite integrals and their properties
- : upper subtract lower, with no because it cancels.
- Swap the limits and flip the sign. Join or split at a point in between. Constants come out and sums split.
- Given and , find (a) and (b) .
- (a) , so and .
- (b) .
- Warning: limits must match before you join. The upper limit of one is the lower limit of the next.
Page 2 of 5Preparing the integrand, trigonometric identities
Expand, or split the top, before integrating
- There is no product or quotient rule for integration, so rewrite until every term is in the table.
- (1) : integrate directly from the table. Any other bracket: expand first. .
- (2) Top degree at least bottom degree: split the top (this is the long division). Top degree less than bottom degree: start integrating.
- Find . Split: . Then .
- Warning: is not of the form , so expand it.
Partial fractions, then integrate
| Denominator | Example | Answer |
|---|---|---|
| degree 1: | ||
| degree 2: |
- Degree 1 denominator , for example : make the numerator and put outside, giving .
- Degree 2 denominator , for example : write it as a power, .
- (a) Express in partial fractions. Set it equal to , so . When , . When , , so . Comparing coefficients of , , so .
- (b) Hence integrate it with respect to : .
- Warning: is a power, not a .
Unknown limits, and undefined integrals
- Given that , where , find . Then , so , so and .
- With terms: let , solve the quadratic in , and keep and the the question allows.
- Some integrals cannot be found. has no value, because does not exist at , which lies between the limits.
- Warning: check the integrand exists from to (a denominator of , or of a negative number).
Identity first: sin squared x, cos squared x, tan squared x
| Square | Identity | Make it the subject | Integral |
|---|---|---|---|
- Use the identity, make the square the subject, then integrate. , and .
- Double the angle as well: , so .
- Find the exact value of . First , so the integral is .
- Then .
- Warning: limits with mean radians (put the calculator in radians for d.p.).
Page 3 of 5Hence questions and the equation of a curvePart 2: hence, curves and areas
Hence: differentiate, then integrate
- If , then . Step 1, consider: write part (a) as an integral. Step 2, rearrange until the wanted integral is on its own.
- (a) Find : . (b) Hence find . Consider , then divide by : .
- (a) Find . (b) Hence evaluate . Consider , so , and dividing by makes the subject.
- Then .
- (c) A quadratic factor in partial fractions: , so .
- Warning: after multiplying or dividing, write again.
Equation of a curve: integrate the gradient
- : write , then Subst the point to find .
- (a) A curve has gradient and a stationary point at . A stationary point (maximum or minimum) is a point on the curve. . Subst : , so , and .
- (b) . The curve has gradient at the point . Find first, from the gradient: , and at , , so .
- Then . Subst : , so and . Two constants: from the gradient first, then from the point.
- Two points and no gradient: integrate twice, write , and Subst both points (the origin first gives at once).
- For the angle of the tangent with the -axis, gradient . Gradient gives . Warning: find before you integrate again.
Page 4 of 5Areas against the x-axis
Area under a curve, with straight edges
- Area , where and are values, taken from the curve straight down to the -axis.
- The limits are the intercepts (solve ) or the intersection points (solve curve line). Straight edges (rectangle, triangle, trapezium) are found by formula, and only the curve needs an integral.
- The curve meets the line at P and the line at Q. Find the area bounded by , , and the two axes. P: , , so P. Q: , , so Q.
- Count the boundaries: five. The region is a rectangle plus the curve part . Required area units.
- Check the size: , because and .
Area below the x-axis
- Above the -axis the integral is a positive value. Below it, the integral is a negative value. Split at the roots, and subtract the negative value.
- Find the total area of the regions bounded by , the axes and the line . In the sketch, A is above the axis (a positive value) and B is below the axis (a negative value), with the minimum at .
- : , or . Total area , where the bracket is the negative value.
- units.
- Warning: integrating straight across the root, , gives , which is wrong.
Area between a curve and a line
- Solve curve line: the values are the limits. Area .
- Find the area of the region enclosed by the curve and the line . Solve , so , , or . The line is the upper boundary and the curve the lower.
- Area units.
- The rule is the same when the region dips below the -axis: it is still upper lower.
Area edged by a tangent: curve and triangle
- The curve cuts the -axis at M. The tangent at the point L on the curve has gradient and cuts the -axis at N. Find the area of the region LMN.
- . Set , so and L is . For M, , so M is .
- Tangent: , so . For N, , so N is .
- Area units. The area is the curve integral subtract the triangle.
Page 5 of 5Areas against the y-axis, and choosing the set-up
Area against the y-axis, and the hence integral of ln
- Horizontal strips: Area , with the subject and -limits, from the graph across to the -axis. and are values. Left of the -axis is a negative value.
- The diagram shows the curve . (a) Find the exact value of . (b) Hence find . Make the subject: , , .
- (a) . The limits are values, and . .
- (b) : , the upper limit. rectangle . A region with two boundaries along the -axis: split where the boundary changes and add the pieces (). Warning: do not mix -limits into .
- Two graphs: Area . and meet at and : Area units.
Which area set-up?
| The region | The set-up | Section |
|---|---|---|
| between the curve and the -axis | , limits from the intercepts | |
| partly below the -axis | split at the roots, subtract the negative value | |
| between a curve and a line | ||
| against the -axis | , the subject, -limits; | |
| edged by a tangent or normal | curve integral triangle or trapezium |
- Between the curve and the -axis: , with limits from the intercepts (section 10). Partly below the -axis: split at the roots and subtract the negative value (section 11).
- Between a curve and a line: (section 12). Against the -axis: with the subject and -limits, or (section 14).
- Edged by a tangent or normal: the curve integral a triangle or trapezium (section 13).
- An area is never negative. State units. For "exact", keep , , and surds.
Worked examples
Integration and Area worked examples
The worked examples for the chapter, with the full working.
Integration reverses differentiation
An antiderivative of is a function with . We write . Every constant differentiates to zero, so one derivative corresponds to a family of functions. A given point determines the constant for the required curve.
The most reliable check is to differentiate your answer. Work on an interval where the integrand is defined; do not integrate straight across a vertical asymptote using an ordinary definite-integral formula.
Standard integrals and the reverse chain factor
| Integrand | Antiderivative | Conditions |
|---|---|---|
| ; stay in its real domain. | ||
| . | ||
| . | ||
| ; radians. | ||
| ; radians. | ||
| ; radians, . |
Differentiating the candidate antiderivative multiplies by , so integrating must divide by to undo it. This shortcut assumes a linear inner expression. If , the integrand is a constant (when defined), which integrates to that constant times . For , adding 1 would produce a zero denominator, so use the logarithm rule instead.
Example 1: powers, a root and a reciprocal
Find , on .
Write the integrand as . Increase each exponent by 1 and divide by that new exponent:
Differentiation gives , confirming the sign of the reciprocal term.
Example 2: a linear inner expression with a negative power
Find , with .
Differentiating produces , exactly the integrand. The result holds on an interval on either side of ; constants on the two separate intervals need not be the same.
Example 3: exponential and trigonometric standard forms
Integrate , using radians.
The sine term integrates to a negative cosine. Each inner multiplier is divided out: for instance, . The result is used only on intervals where .
Example 4: a logarithm with a negative inner coefficient
Find , where .
Indeed the derivative is . If a question restricts , write ; for , write . Absolute values allow one formula on either valid interval.
Prepare the integrand before integrating
There is no general rule that integrates a product by multiplying two antiderivatives. Expand, divide, use partial fractions or apply an identity to reveal standard forms. A question's earlier differentiation result can also supply exactly the antiderivative you need.
Example 5: expand a square first
Integrate for .
The middle term is , because . You cannot simply increase the outer square's exponent: its inner derivative is not a constant.
Example 6: split a rational function into partial fractions
Integrate , where .
Multiplying through gives , so and . Thus , and
Differentiate and combine fractions to recover the original numerator. Use the answer on an interval avoiding both excluded inputs. If the numerator's degree is at least the denominator's, divide first.
Example 7: use an identity for a squared trigonometric function
Find , with radians.
From , rewrite . Then
Its derivative is , the original squared sine. Similarly, and prepare other integrals.
Example 8: use a given derivative to integrate a product
Differentiate , and hence find .
Rearrange the identity before integrating:
Differentiating the answer makes the two terms cancel. This “hence” method uses the supplied derivative; it does not require a new general integration rule.
Recover the function from its derivatives
Example 9: one point fixes one constant
A curve has and passes through . Find its equation.
Substitute the point into the function, not into its derivative: , so . The equation is . Its derivative and its value at 2 both match the given information.
Example 10: integrate twice and use two independent conditions
Given , and , find .
Therefore . Each integration introduces its own constant. If instead two points on the curve are given, integrate to and solve the two resulting equations together.
Definite integrals give signed accumulation
If throughout an interval where is continuous, then . As the upper endpoint moves, the accumulated signed area changes at rate ; this is why an antiderivative measures the accumulation.
With , portions above the x-axis contribute positively and portions below contribute negatively. Geometric area is non-negative: split at roots and add the magnitudes. Reversing the limits changes an integral's sign, and equal limits give zero. There is no in the final definite value because it cancels in .
Example 11: signed integral versus total area
For , find the signed integral and the total area between the graph and the x-axis from to .
The graph crosses the axis at 1. It is negative on and positive on . Therefore
Taking the absolute value of the unsplit integral would give , which is still wrong for the total area. Two triangles of areas and 2 confirm the answer.
Regions bounded by a curve and straight lines
Sketch the boundaries and find their intersections. For vertical strips, area is . If the upper boundary changes, split the integral there. For horizontal strips, use with limits in . Choosing the variable can turn an awkward region into a standard integral.
Example 12: a line and a parabola
Find the area enclosed by and .
At the intersections, , so and . For , the line is above the parabola. Hence
The integrand is the vertical distance between the two boundaries. Subtracting in the opposite order would produce a negative signed value.
Example 13: horizontal strips avoid integrating a logarithm
Find the area bounded by , , and .
Rearrange the curve as . For each , the left boundary is and the right boundary is . Therefore
The units are square units. The curve itself requires ; the separate boundary line is not being substituted into the logarithm. The limits are y-values because the strips are horizontal.
Explore cancellation across the x-axis
Keep the lower limit at 0 and move the upper limit for . Before moving it, predict the signed integral when : equal triangles cancel even though their total area is positive.
From 0 to 3: signed integral = 1.5; total area = 2.5 square units.
Common mistakes and useful checks
- Using the power rule for : its antiderivative is , not .
- Multiplying by the inner coefficient: a linear inner expression requires division when integrating.
- Forgetting a constant: include one per indefinite integration and use the correct point or gradient condition.
- Dropping absolute values: alone does not cover a negative-x interval for .
- Taking one absolute value at the end: split the area at every sign change first.
- Crossing an undefined input: the ordinary definite-integral rule cannot be applied across a vertical asymptote.
- Mixing strip directions: use x-limits with and y-limits with .
Continue with topic practice
Use the Secondary 4 integration practice bank for exam questions and their worked solutions. Attempt a question on paper before comparing methods. This guide supports Secondary 4 learning and revision of the full Secondary Additional Mathematics course.