E Maths (K310) · Notes
Find the mean, median and mode, use standard deviation, read cumulative frequency curves and quartiles, and read and draw the statistical diagrams.
Statistics summary sheet: every method on 3 pages
A summary of the whole statistics chapter on three pages.
Page 1 of 3 Averages, range and standard deviation
E Maths summary notes
Statistics methods, section by section
Page 1 of 3Averages, range and standard deviation
Mean, median, mode and range: from a list and from a frequency table
| Mark | Cumulative | Note | ||
|---|---|---|---|---|
| 10th and 11th values | ||||
| total |
- The mean is the sum of the values divided by the number of values. The median is the middle value once the data is in order. The mode is the most common value. The range is the largest value minus the smallest.
- (a) For , in order they are . The mean is , the median is 6 (the 4th of 7), the mode is 6 and the range is .
- (b) For 20 pupils' marks in a table, add columns and cumulative . The total of is 20 and the total of is 53, so the mean is .
- The 10th and 11th values are both 3 (cumulative frequency 16 at mark 3), so the median is 3.
- Warning: the mean of a table is . Do not add the column and divide by 4.
Standard deviation: calculating it and comparing spread
- The standard deviation is . Check with the calculator: enter the values (or and ), then read the mean and .
- (a) For the mean is and . So .
- Two classes with the same mean can have different spread. Class A has a smaller SD and class B a larger SD on the dot plots.
- A smaller SD means the values are closer to the mean and more consistent. A larger SD means more spread out.
- (b) Team A has mean 62 and SD 4, and Team B has mean 58 and SD 9. Team A has the higher mean, so its scores are higher on average, and the smaller SD, so its scores are more consistent.
- Warning: always say both. Write “higher on average” for the mean and “more consistent” for the SD.
Page 2 of 3Cumulative frequency, box plots and stem-and-leaf diagrams
Cumulative frequency curve: median, quartiles, interquartile range and counting
- Plot cumulative frequency against the upper end of each class. Read from the vertical axis across to the curve, then down.
- With , the median is the 40th value, the 20th and the 60th. Reading the curve gives 35, 25 and 45 minutes.
- The interquartile range is .
- (a) To find how many took more than 55 minutes, read the cumulative frequency at 55 minutes, which is 71. Then people.
- (b) To find how many took less than 30 minutes, read the cumulative frequency at 30 minutes, which is 26.
- Warning: “more than” needs minus the reading, not the reading itself.
Box plots and stem-and-leaf diagrams: five numbers, IQR and comparing
| Stem | Leaves |
|---|---|
- A box plot shows the five numbers: minimum, , median, , maximum. In the example they are 8, 25, 35, 45 and 62, so the range is 54 and the IQR is 20.
- A quarter of the data lies in each section: whisker, half the box, half the box, whisker.
- (a) To show as a stem-and-leaf diagram, use stems 1, 2, 3, 4 with leaves , , and . The key is means 24, and the median is the 5th value, 24.
- (b) Box plot A has median 35 and IQR 20; box plot B has median 42 and IQR 12. B has the higher median, so its values are higher on average. B has the smaller IQR, so its middle half is less spread out and B is more consistent.
- Warning: write a key, and keep the leaves in order, each digit in its own column.
Page 3 of 3Histograms, pie charts, correlation and sampling
Histograms and pie charts: frequency density and angles
| Class | Width | Freq | Density |
|---|---|---|---|
- For unequal classes, plot frequency density. Bar height is the density and bar area is the frequency: .
- In the table the densities are , , and . The bar has area , which is the frequency.
- For a pie chart of 60 pupils (Bus 12, Walk 18, Car 6, MRT 24), 1 pupil is .
- The angles are Bus , Walk , Car and MRT . Check: .
- Warning: a histogram with unequal widths needs density. Do not plot the frequency itself.
Correlation, sampling and misleading graphs: scatter diagrams, bias and truncated axes
- For scatter diagrams, describe the link (positive, negative or none) and draw a line of best fit through the middle of the points.
- Correlation does not prove one thing causes the other.
- Misleading bar graphs: with the axis starting at 0, 95 and 100 look close. With the axis starting at 92, 95 and 100 look very different.
- Sampling: a fair sample is random and large enough, from the whole population. Asking only the members of a gym about exercise is biased.
- For hours of study and test mark the correlation is positive: more study, higher marks. For outdoor temperature and sales of hot drinks it is negative: hotter, fewer hot drinks.
- Warning: name the fault. Write “the vertical axis does not start at 0” or “the sample is biased”.